Wet Dry Mix Add Parallel Processor Construction Information

Construction information for DIY projects, including the MS Mid Side Matrix, Elliptic Equalizer, Mastering Console, Phono Transfer System, Insert Switcher and the Dual Class-A Amplifier. You can post your baby pictures here.
Post Reply
User avatar
mediatechnology
Posts: 5116
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Wet Dry Mix Add Parallel Processor Construction Information

Post by mediatechnology »

This thread provides construction information for the Wet Dry Mix Add Parallel Processor.

See: https://proaudiodesignforum.com/forum/p ... =20#p16938

Product pages for the Wet Dry Mix Add "WDMA" Parallel Processor: https://ka-electronics.com/shop/index.p ... 0Processor

Wet Dry Mix Add Preiminary Assembly Instructions: https://ka-electronics.com/images/pdf/W ... 2122_1.pdf

Mouser Project Manager bill of materials: https://www.mouser.com/ProjectManager/P ... 09c51b12f8

A low cost 4 section 10KΩ linear pot you can use for test: https://www.mouser.com/ProductDetail/65 ... -2020KB103

Image

Image
User avatar
mediatechnology
Posts: 5116
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: Wet Dry Mix Add Parallel Processor Construction Information

Post by mediatechnology »

Wet Dry Mix Add Preiminary Assembly Instructions

https://ka-electronics.com/images/pdf/W ... 2122_1.pdf

I'll be adding final test instructions soon...
GillesF
Posts: 2
Joined: Sat Oct 29, 2022 7:17 am

Re: Wet Dry Mix Add Parallel Processor Construction Information

Post by GillesF »

Hi, do you think it's a proper way to use this board?
I guess using an Y shaped connection to feed dry input would not be a problem/audible but I’m not 100% sure.
Attachments
schema-logique.png
User avatar
mediatechnology
Posts: 5116
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: Wet Dry Mix Add Parallel Processor Construction Information

Post by mediatechnology »

Hi Gilles - Thank you for joining us!

This week I found a good anti-spam service and can now have open registration. In just under 2 days it's blocked over 1000 bogus registrations. It's nice to see yours, a real one, self-registered.

A "Y" cord bridging connection is indeed the correct way to obtain the Dry feed.

I'm behind on my documentation and others have also asked the same question.
I hope to have the final test procedures written and posted soon.

The Dry input to the WDMA simply bridges the input to the compressor, EQ or the send to any other Wet device being used.
The Dry input is a 1246 line input so the differential impedance, 24KΩ, doesn't significantly load the source and affect level.
I was originally going to put the extra loop-through connector on the board for the Wet Send but just ran out of real estate.

Thanks again for dropping in!
GillesF
Posts: 2
Joined: Sat Oct 29, 2022 7:17 am

Re: Wet Dry Mix Add Parallel Processor Construction Information

Post by GillesF »

Thank you!
Post Reply