Texar Prism clone prototype Finished Version

Where we discuss new analog design ideas for Pro Audio and modern spins on vintage ones.
Gold
Posts: 648
Joined: Sat Dec 01, 2007 6:20 pm

Re: Texar Prism clone prototype Finished Version

Post by Gold » Fri Dec 31, 2021 12:24 pm

mediatechnology wrote:
Thu Dec 30, 2021 1:05 pm
Are there any issues sourcing the MLCC caps?
I have an open cart at Mouser right now for another project and haven't checked them.
I’ve noticed lately that Mouser is picked over. I couldn’t get some non exotic aluminum electrolytic caps in the form factor I needed in any brand. Digikey has much better stock these days. Shhh….

User avatar
mediatechnology
Posts: 4982
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: Texar Prism clone prototype Finished Version

Post by mediatechnology » Fri Dec 31, 2021 12:28 pm

I've been seeing Mouser come up short on aluminum electrolytics and 1% resistors.
In both product areas I've been able to get them at DigiKey.

Mouser has some Nichicon caps I stock on back-order until November 2022.

Gold
Posts: 648
Joined: Sat Dec 01, 2007 6:20 pm

Re: Texar Prism clone prototype Finished Version

Post by Gold » Fri Dec 31, 2021 1:16 pm

I was trying to get 470uf 50v in a 10mm diameter. I usually use Nichicon HE but all I could find are Epcos at Digikey.

Post Reply